Overview
These die-cut replacement lens gaskets are a direct replacement for the factory fitted item. Reproduced from original samples.
Prevents water from leaking between the lens and body/bezel.
Suitable for use on AP5/AP6 vehicles, fitted to the tail lights.
Reproduction Lens and Housing Seals
Hemi Performance have reproduced almost every lens and housing seal used on the Valiant motor vehicles.
Through careful removal and repair of old gaskets, or creating new dies based off of original lenses or housings, we've been able to re-create the seals to the original specifications to ensure that your lenses don't leak.
All of our lens and housing seals are proudly manufactured in Australia.
Customer Reviews
- look just like original By steve (posted on 11/06/2024)
- fitted just like originals
- fits as it should By george (posted on 22/04/2023)
- seals well
- Perfect By Mike (posted on 19/08/2022)
- Just what i was after
- Perfect replacement for old ones By BOB (posted on 1/04/2022)
- Perfect reproduction fitted perfectly would recommend %uD83D%uDC4C
- Not what I was expecting By Ray (posted on 27/05/2020)
- These are just cut from 5mm thick foam rubber, they are not moulded reproduction rubber. Had I have seen them first I would not have purchased them. I wont be using them that's for sure.
- ???? By Derek (posted on 6/12/2019)
- I haven't used them yet
- Not the best fit By phil (posted on 22/08/2019)
- This seal is about 4 or 5 times thicker than it needs to be, they were too thick to use, so I reverted to a more appropriate item from Clark Rubber
Additional Information
| SKU | 116.64698 |
|---|---|
| Factory Comparison | Direct Replacement |
| Sale Unit | Set of 2 |
| Legacy Part Number | LS-AP3 |