Overview
Weather you're building a high performance street car, or a daily driver, fitting a sway bar to your vehicle will give you better handling when you need it.
This complete conversion kit includes a high quality 18mm bar, as well as the required brackets, bolts and bushes to get the job done right.
This kit is proudly hand-crafted in Australia by a second generation metalworker to ensure perfect fit and longevity.
Can be installed on all Chrysler/Valiant models (RV1, SV1, AP5, AP6, VC, VE, VF, VG, VH, VJ, VK, CL & CM.)
Customer Reviews
- Good product. By Steve (posted on 5/09/2024)
- Good looking and well built product. Product works well and has stiffened up the back end of the VG.
- Too small By Darren (posted on 6/09/2023)
- The bar is like it was meant for a centura or something small. The bar doesn't even reach the mounting points on chassis that you have to drill. The brackets for ubolts needed drilling out, they were a mm too small.
- Good bar, some A body mods may be required By Andrew (posted on 31/03/2023)
- I had to build some mounts to fit a 65mm of rear axle tube as this kit defaults to later 1970 on axle size, but this was minimal and I reused almost everything int the kit to do this except the u-bolts. I also chose to sleeve the bracket holes in the rear subframe to avoid them being crushed over time but I am not 100% sure this is necessary. I also installed a front sway bar. This is a really good idea.
- Not a bad kit. Missing the diagram photo of what it should look like installed. By Shaun (posted on 7/11/2021)
- Sway bar needs to be 50mm longer at both connection ends, Not cranked down so much at the diff head by 20mm, Link rods need to be 50mm longer and they could do with a hex or flat portion in the middle to adjust a shifter to hold. Supplied bolts for hanger angle brackets head and nuts different sizes.
- Average By Aaron (posted on 5/02/2021)
- Average
- Average By Aaron (posted on 5/02/2021)
- No installation manual given and some of the parts are the wrong size for my axle tube size(85mm supplied but needed 65mm)
- Perfect fit By Frank (posted on 1/07/2020)
- 5 star
- Very good quality. By Dan (posted on 1/07/2020)
- Fits perfectly, keeps rear end stable.
- needs extra bits By Simon (posted on 13/09/2019)
- This needs to come with a solid tube for the inside of chassis rail, you cant just drill a hole and put bolt through as it will crush the rail under pressure
- Great product, very pleased. By Barry (posted on 14/08/2018)
- Very pleased with the kit, everything required was present, and all made to a high quality, and very pleased with the handling of the car after installation and would highly recommend to anyone who was thinking of purchasing one. In fact, will probably order another unit to go in my other Charger
Additional Information
| SKU | 103.72998 |
|---|---|
| Factory Comparison | Retro-fit Replacement |
| Sale Unit | Each |
| Legacy Part Number | HPSG3B |